- Settings for a raw blaclck and white scan with silverfast 6.6 driver#
- Settings for a raw blaclck and white scan with silverfast 6.6 manual#
- Settings for a raw blaclck and white scan with silverfast 6.6 software#
Adjustments would only be required if there was a problem recognising the orientation of the slide.
Settings for a raw blaclck and white scan with silverfast 6.6 software#
With the current software and firmware, the automatic recognition of the scanning area works perfectly. This can be reduced by placing it on a towel or similar. The scanner makes a certain amount of noise when in use and also vibrates. With the DigitDia 5000, there is hardly any difference in scanning time, but the results are sometimes dramatically better. For scanning colour slides, (the only type of film I have scanned to date) the Generic Positive setting gives the best results.Ħ.1.2.2 Advanced Setting With the current software and firmware, JS recommends use of Auto Exposure.
The selection is shown in the Toolbar to the right of the file type icon. 5.2.2.9 Set Current Position See section 6.2.2.ĥ.2.4 Define Measurement Units In the top left of the Preview window, there is a clickable square which determines the measurement units – inches, centimetres or pixels – this can be useful when defining the Default Scanning Area – section 6.1.2.3.Ħ Scanner Operations 6.1 Define Basic Settings 6.1.1 Film Type The film type is selected from the main categories – Negative, Positive, B&W (Black and White) and then from the specific film type, as listed in section 5.2.2.1.
5.2.2.8 Reload Magazine Click every time a new magazine is loaded – see section 6.2.2. There is a button on the scanner which performs the same operation. 5.2.2.7 Forward One Frame Just moves the magazine one slide forward – does not initiate a scan. 5.2.1.6 Help Menu ĥ.2.2 Cyberview Toolbar Image Adjustment Pre-scan Film Type Scan Output Preview Forward/ Backward One Frame Set Current Position Reload Magazine e Go To 5.2.2.ĥ.2.2.5 Output Preview See section 7.1.2 5.2.2.6 Backward One Frame Just moves the magazine one slide backward – does not initiate a scan.
Settings for a raw blaclck and white scan with silverfast 6.6 manual#
Check the first two items and ignore the third – the User Manual will not help. If Cyberview cannot be started for any reason, the following error message is usually displayed.
after the first Pre-scan, the Thumbnail Panel is always displayed when Cyberview is active. On my installation, the Close function is disabled, i.e. It can be dragged anywhere on the desktop, i.e. The Thumbnail Panel only appears when Pre-scan is selected for the first time (section 6.3). This window may be displayed differently, according to whatever settings have been previously selected in Cyberview. The following message is displayed It takes about 3 minutes for the scanner to initialise, then the Cyberview Preview window appears as shown below. After reboot, reload the Cyberview CD into the drive.ĥ Working with Cyberview 5.1 Starting Cyberview Turn on the scanner before starting Cyberview, then double click on the Cyberview icon on the desktop, or select Start > Programs > Cyberview. This contradicts the Cyberview Instruction Manual. The Installation Wizard instructs you to take the CD out of the drive before rebooting (presumably so it will not be mistaken for a System Disk on reboot). The Installation Wizard should start automatically – see section 4.3 if it does not.